Source.Power.DC.Simulated

SourceElectrical

The process of sourcing a sinusoidal DC Power signal from a device where the Volts and Amps are provided on two different outputs and measured by the UUT as Watts / Power. This test process can be used by any device that measures AC power with separate voltage and current inputs.

Result

Name	Quantity	m-layer aspect
Power	power	power (AS19)

Parameters

Parameter	Required	Quantity	m-layer aspect	Definition or allowed values
Power	Required	power	power (AS19)	—
Voltage	Required	voltage	electric-potential (AS22)	—
Current	Required	current	electric-current (AS5)	—

Taxa from the NCSLI MII Measurand Taxonomy Catalog, published by NCSL International, Measurement Information Infrastructure (MII) & Automation Committee, used under CC BY-SA 4.0. Converted from XML to JSON and reformatted for display. Taxon content is unchanged. This section’s taxonomy content stays under CC BY-SA 4.0; the rest of the site is CC BY 4.0.

The materials and information contained herein are provided and promulgated as an industry aid and guide, and are based on standards, formulae, and techniques recognized by NCSL International. The materials are prepared without reference to any specific federal, state, or local laws or regulations, and NCSL International does not warrant or guarantee any specific result when relied upon. The materials provide a guide or recommended practices and are not all-inclusive. From time-to-time commercial equipment, instruments, or materials are identified in technical publications to foster understanding. Such identification does not imply recommendation or endorsement by the NCSL International, nor does it imply that the materials or equipment identified are necessarily the best available for the purpose.