Source.Voltage.Shorted

SourceElectrical

This process connects a Short to the input of a measurement device and measures the no signal applied Voltage. This is The test process is typically used to measure the UUT’s Zero Volts DC floor values.

Result

Name	Quantity	m-layer aspect
Voltage	voltage	electric-potential (AS22)

Parameters

Parameter	Required	Quantity	m-layer aspect	Definition or allowed values
Voltage	Required	voltage	electric-potential (AS22)	—

Taxa from the NCSLI MII Measurand Taxonomy Catalog, published by NCSL International, Measurement Information Infrastructure (MII) & Automation Committee, used under CC BY-SA 4.0. Converted from XML to JSON and reformatted for display. Taxon content is unchanged. This section’s taxonomy content stays under CC BY-SA 4.0; the rest of the site is CC BY 4.0.

The materials and information contained herein are provided and promulgated as an industry aid and guide, and are based on standards, formulae, and techniques recognized by NCSL International. The materials are prepared without reference to any specific federal, state, or local laws or regulations, and NCSL International does not warrant or guarantee any specific result when relied upon. The materials provide a guide or recommended practices and are not all-inclusive. From time-to-time commercial equipment, instruments, or materials are identified in technical publications to foster understanding. Such identification does not imply recommendation or endorsement by the NCSL International, nor does it imply that the materials or equipment identified are necessarily the best available for the purpose.